Waterslide Decal – Circle 02 (S)MT-37

Enhance your scale models with the MT-37 (S) Waterslide Decal – Circle. Available in multiple diameters from 1.5mm to 2.9mm, these high-quality decals are perfect for adding precise details to your models.
Instructions for Use:

1. Cut out the desired waterslide decal with scissors or a craft knife.

2. Soak the decal in water or warm water for a few seconds.

3. Once the decal slides off the backing paper, use tweezers to carefully place it onto the model, front side up.

4. Gently blot with a cotton swab to remove excess water and press out air bubbles. Avoid touching before fully dry.

5. After completely dry, spray a clear protective coat to enhance adhesion and durability.

Notes:

• Clean the model surface with mild dish soap or model cleaning solution to remove grease and dust. Avoid strong solvents.

• Prepare scissors, tweezers, cotton swabs, and other tools in advance.

• For curved surfaces, a decal softener or setting solution is recommended (sold separately).

• Remaining decals can be stored or reused according to preference.